How to cover-up Anet A8 3D Printer and add extra cooling fan in casing | 3D Printer Upgrade2

This post will guide you to install old laptop cooling fan inside 3D Printer Anet A8 Main Board casing for better heat sink & avoid burning circuits.

Print the casing: https://www.thingiverse.com/thing:2097115

Get the cooling fan: https://www.amazon.in/gp/product/B07B48TK5S/ref=oh_aui_detailpage_o08_s00?ie=UTF8&psc=1

This fan can be connected to max 5V. Please note the FAN1/2 of Anet Board are supplied with 12V so, don't connect to them unless you have a cooling fan with 12V.

• Cut the Female 3 PIN connector of cooling FAN & solder Female jumpers of another side to RED,BLACK for VCC,GND respectively.
• 
• Connect VCC & GND to cooling FAN and fix inside casing like below this will reduce the heat from heat sinks efficiently while the casing is covered-up.

Read How to upgrade Anet A8/A6 3D Printer Firmware Marlin using Arduino Nano/Uno in Arduino IDE- Solution of sync error: http://www.vslcreations.com/2018/08/how-to-upgrade-anet-a8a6-3d-printer.html

12:53